dji MATRICE 300 RTK Посібник з технічного обслуговування - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з технічного обслуговування для Дрони dji MATRICE 300 RTK. dji MATRICE 300 RTK 19 сторінок. Dual gimbal connector
Також для dji MATRICE 300 RTK: Інформація про продукт (17 сторінок), Посібник з технічного обслуговування (19 сторінок), Посібник користувача (15 сторінок), Посібник із швидкого старту (10 сторінок), Інформація про продукт (10 сторінок)
Друкувати сторінку
MATRICE 300 RTK Maintenance Manual
Flight Test Checklist
Type
Essentials
1. Make sure that there are no potential safety hazards or people within 5 m of the
aircraft.
2. Make sure that the satellite count is more than 10 and there is sufficient light.
Start video recording.
3. In P-mode, perform CSC to make the motors spin at an idle speed on the
ground. Push the control sticks in each direction lightly to test. Then push the
throttle stick down to the bottom until the motors stop.
4. In P-mode, perform CSC to make the motors spin at an idle speed on the ground.
Observe to check if the aircraft shakes. Then push the throttle stick down to the
bottom until the motors stop.
5. In P-mode, take off and then hover at a height of 5 m for 1 min. Check to see the
aircraft horizontal drift is no more than 1 m and the height drift is no more than
0.5 m. Check the shake of the aircraft, battery status, sound of the motors and
Flight Test
propellers.
6. Push the control sticks in each direction lightly to check if the aircraft responds
correctly.
7. Gradually increase the movement of the control sticks to observe the attitude
response and the shake of the aircraft when braking.
8. Set height limits and distance limits. Then test if the aircraft can obey the limits.
9. In P-mode, enable obstacle sensing. Then test if the aircraft can avoid obstacles
in left, right, front, rear, and upward directions.
10. In P-mode, fly the aircraft more than 20 m away from the Home Point at an
11. Stop video recording after landing.
1. The propellers, motors, and aircraft body are intact, and there is no sign for
Checklist after
collision or loose or broken structures.
Landing
2. The temperature of the motors is normal, no signs of uneven heating.
Regular Maintenance
It is recommended to perform inspection and maintenance regularly by following the standards below
to keep the aircraft in a good condition and reduce safety risks.
Maintenance Standard
Type
Maintenance Items
1. Regular maintenance items
Basic
2. Updates and calibration
Maintenance
3. Deep cleaning
8
©
2020 DJI All Rights Reserved.
altitude less than the preset RTH altitude. Initial RTH using the RTH button on
the remote controller to test if the aircraft can perform ascending, cruising,
landing in order and the landing position has an error no more than 1 m from
the Home Point.
Maintenance
Advice
Total flight time is 200 hours, or
Factory service
the product has been used for 6
recommended
Period
months.