ARTHUR HOLM AH15D X2HDGA Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Монітор ARTHUR HOLM AH15D X2HDGA. ARTHUR HOLM AH15D X2HDGA 14 сторінок. Hdcp compliant retractable monitors for furniture integration
Друкувати сторінку
CONTROLS
Remote IR control
POWER
Switch ON/OFF the monitor
MENU
Activates the OSD menu on screen
UP
Cursor control up on the OSD menu
DOWN
Cursor control down on the OSD menu
LEFT
Cursor control left on the OSD menu
RIGHT
Cursor control right on the OSD menu
OK
Selects the function on the OSD menu. When the OSD
menu is not active on screen, selects the input source
Monitor address
Below the monitor, there is a screen to configure the monitor. Press
the UP or DOWN buttons to change the function. Press the OK button
to select the function. Change the parameter using the UP or DOWN
buttons and press OK again to save the changes.
AHNET ID
Selects the number AHnet ID to RS422 to externally
control the monitor
INPUT SELECT
Selects the input source signal (DVIA, DVI1 or DVI2)
BRIGHTNESS
Configuration of the monitor brightness level
CONTRAST
Configuration of the monitor contrast level
BACKLIGHT
Configuration of the monitor backlight level
STATUS INFORMATION List of the monitor status to service
10
CONTROLS
IR sensor
The IR sensor is located on the lower right side of the screen.
Monitor movement controls
On the upper cover plate, there are two buttons to control the UP and
DOWN monitor movements.
2. UP BUTTON CONTROL
1. DOWN BUTTON CONTROL
1. Retracting the monitor:
It is recommended that no objects or parts of the body that could
obstruct the retracting movement of the display, are not on the top
of the cover plate.
To retract the monitor display, press the front button (1) on the right
hand side of the cover plate.
2. Raising the monitor:
It is recommended that no objects or parts of the body that could
obstruct the rising of the display, are not on the top of the cover
plate.
To rise up the monitor display, press the rear button (2) on the right
hand side of the cover plate. Pressing this button when the monitor is
raised, activates the auto config function for the ARGB input signal.
11