ARTHUR HOLM DynamicCableRetract Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Кабелі та роз'єми ARTHUR HOLM DynamicCableRetract. ARTHUR HOLM DynamicCableRetract 10 сторінок.

Друкувати сторінку

INTRODUCTION

The DynamicCableRetract device is prepared to be mounted from

below the table.

A cover plate is supplied if the hole on the table can't be made

properly or if aesthetically is required.

Included in all versions are all necessary brackets for the installation.

ATTENTION

Manipulation of the product should be avoided, no stress should be applied to the product except from the

instructions given in this document. Cutting, drilling, soldering, adding of electrical and mechanical

components can cause danger and should be avoided by all mean. Not complying with these direction will

result in a lost of the Arthur Holm warranty. Albiral Display Solution S.L. shall not be held liable for any loss

or injury incurred as a result of modifications made to goods by anyone other than the supplier or the

supplier's authorised representative without the supplier's written permission. Such modifications shall be

deemed to terminate any further guarantee obligations. Compensation will not be paid for wages, loss of

profit, waste of time, packing and transport or any financial liability resulting from defects in the goods.

(Albiral Display Solutions shall not be liable for any loss or injury caused by negligence.)

Information