dji Dropsafe Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари для дронів та квадрокоптерів dji Dropsafe. dji Dropsafe 14 сторінок.

Installing DJI Dropsafe System

System base is attached to parachute housing by default. To set up the system

base, you need to detach the system base from the parachute housing. Follow

the steps below to detach the system base from the parachute housing:

1. Remove the cover, then take off the winglets and side strips.

2. Remove the screw and take off parachute housing.

3. Unscrew the manifold.

Stick one of the attachment pads onto the bottom of the DJI Dropsafe system base, and the other pad to the

center of your aircraft's upper plate. Then secure the system base to your aircraft by pressing the attachment

pad on the system base against the attachment pad on the aircraft.

Caution: The system base must be placed in the center of the aircraft's upper plate to achieve

optimal performance.

Configure Remote Controller Switches

Two remote controller switches must be configured for proper use of the DJI Dropsafe: one is a "safety switch",

and the other is an "activation switch" used to activate and deploy the system. Follow the instructions below. For the

details on how to configure the channel assignment of the switches, refer to your remote controller's user manual.

1. Recommend to select a trainer switch to act as the "safety switch".

2. Select a 2-position switch to act as the "activation switch".

Remote Controller and Flight Controller Connection

The DJI Dropsafe system base must be connected to your flight controller and RC receiver to function

properly. Refer to the diagram below to complete the connections:

For A2 flight control system, connect the ECO and WK ports on the system base to the X3 and F4 ports on

your flight controller. Then, connect the RC2 port on the system base to the port on the RC receiver that will

be used as an "activation switch" to activate and deploy the DJI Dropsafe. Lastly, connect the RC1 port on the

system base to the port on the RC receiver that will be used as a "safety switch".

The DJI Dropsafe system can be deployed by A2 flight control system automatically. Upgrade the

A2 controller unit firmware to 2.4 version or above and enable the parachute function in A2 Assistant

to use the DJI Dropsafe system with A2 flight control system.

ECO

DJI Dropsafe

Connection Ports

RC2

RC1

A2 Flight Controller

Channel for

Remote

activation switch

Controller

Channel for

Reciever

safety switch