ArtiCure ASU Посібник із швидкого старту - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Медичне обладнання ArtiCure ASU. ArtiCure ASU 4 сторінки.

Instructions for Use

1 / Ensure all ASU and ASB cable connections are

secure according to the schematic on page 2.

2 / Power on the ASU and ASB by activating switches

on the back of each machine.

• If there is no power after this step, check

snugness of power cable and (if applicable)

that the main power switch on the cart is

turned on. This main power switch is located on

the very bottom of the front of the cart.

3 / With the connector alignment arrow in

the 12 o'clock position, push the Footswitch

Connector into the Footswitch Receptacle

on the front of the ASB. The Footswitch may

be connected when powered up, or prior to

powering up the ASU.

4 / Connect Handpiece(s) with the arrow facing

upward into the appropriate receptacle(s) on the

ASB switch box as shown on page 2.

5 / Select the desired channel for use. Only one

ASB channel may be active at a time. Using

ASB selector knob, select the device that

requires power.

Note: Example shows ASB configured to power an Isolator

Clamp or Isolator Synergy Access

"Isolator Dual" channel.

Synergy

Clamp that is plugged in to the

6 / When all of the above conditions have been met,

the ASU screen will read "READY" and "Depress

footswitch to begin."

7 / Position the Handpiece.

• To position the Handpiece, follow the

Instructions for Use provided with the

Handpiece.

8 / Deliver RF Energy.

• Press the Footswitch to initiate RF energy

output. RF energy output is terminated by

releasing the Footswitch or at the end of 40

continuous seconds of energy delivery. The

display screen of the ASU will indicate that

the generator is in the RF ON mode.

™