djm direct 01985-V2 Оригінальна інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Пила. djm direct 01985-V2. djm direct 01985-V2 17 сторінок.

Друкувати сторінку

9. Technical Data

Specifications:

Mains Voltage -

Power Consumption -

No Load Speed -

Blade Spec -

Cutting Capacity:

At 90 degrees -

At 45 degrees -

Height adjustment -

Saw blade swivel -

10. Assembly & Installation

Avoid unintentional starting of the machine. During assembly and

for all work on the machine, the power plug must not be connected

to the mains supply.

Carefully remove all parts included in the delivery from their

packaging.

Remove all packaging material from the machine and the accessories

provided.

Before starting the operation of the machine for the first time, check

if all parts listed in the box content section have been supplied

Note: Check the power tool for possible damage. Before further use

of the machine, check that all protective devices are fully functional.

Any lightly damaged parts must be carefully checked to ensure

flawless operation of the tool. All parts must be properly mounted

and all conditions fulfilled that ensure faultless operation.

Damaged protective devices and parts must be immediately replaced

by an authorised service centre.

Dust extraction

Dust from materials such as lead-containing paint, different kinds of

wood, minerals and metal maybe harmful to health. Touching of

inhaling the dust can cause allergic reactions and/or ailments of the

respiratory tract of the user or persons in the vicinity. Certain dust

such as oak or beech dust is considered carcinogenic, particularly in

combination with wood treatment additives (chromate, wood

preservatives). Materials containing asbestos may only be processed

by experts.

– Always use a dust extraction facility.

– Make sure the workplace is well ventilated.

– Always wear a dust protection mask.

– Observe the regulations valid in your country for the materials to

be processed.

220-240V / 50Hz

S1 1800W;

S6 25% 2000W

5000rpm

250x30x24T

85mm

65mm

0-85mm

0-45°

Attach the Table Extensions

1. Make sure that the saw blade is at its lowest setting. Turn the saw

upside down and place it on the floor with the table facing down.

2.Line the table extension (8) up with the edge of the saw table (1).

3. Loosely fasten the extension to the table using hexagon head

screws (20) and nuts (21) or Extension table support rod(24). Repeat

the procedure on the opposite side of the table.

4. Screw the support struts (23) to the table extensions with washers

and nuts.

5. Tighten the nuts when both extensions have been attached.

Note: The side table support struts (23) are supplied in two sizes. The

longer 2 should be fitted to the left hand side of the machine, the

shorter two on the right, and should be attached to the outer flange

of the extension panels. Fasten one end of the support strut to the

inside of the extension panel using the rearmost hole. Repeat this

step on both sides.

The other end of the support strut attaches to the top of its

accompanying corner leg.

• Carefully remove the relevant machine screw from the top of the

corner leg.