Artila Matrix 522 Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Промисловий ПК Artila Matrix 522. Artila Matrix 522 10 сторінок. Arm9-based linux ready industrial computer
Друкувати сторінкуReset Button
Press the "Reset" button to activate the hardware reset.
You should only use this function if the software does
not function properly.
Power LED
The Power LED will show solid green if power is
properly applied
Ready LED
The Ready LED will show solid green if Matrix 522
complete system boot up. If Ready LED is off during
system boot up, please check if power input is correct.
Turn off the power and restart Matrix 522 again. If
Ready LED is still off, please contact the manufacture
for technical support.
Link/Act LED
When Ethernet port are connected to the network, Link/
Act will show solid green and if there is traffic in the
Ethernet, this LED will flash.
Serial/CAN Port LED
The dual color LEDs indicate the data traffic at the
serial bus and CAN bus. When RXD line is high then
Green light is ON and when TXD line is high, Yellow
light is ON.
Ethernet Port
Serial Ports:
Port 1~2: 3-in-1 Software Configurable
RS-232/422/485
NOTE: Only Port 2 has full modem signals
DSR,DTR, DCD
Pin Assignment and Definition
Serial Port (DB9 Male)
Pin No.
RS-232
RS-422
RS-485
—
1
DCD*
TXD-
—
2
RXD
TXD+
3
TXD
RXD+
DATA+
4
DTR*
RXD-
DATA-
5
GND
GND
GND
—
—
6
DSR*
—
—
7
RTS
—
—
8
CTS
—
—
9
---
CAN Port (DB9 Male)
Matrix-522 features two 2500 Vrms fully isolated CAN
ports. A 120 Ohm terminator is applied between CAN_H
and CAN_ L that can be disabled by removing jumper J7
and J8. A shielding ground is available at Pin 3 of the DB9
connector.
Serial Console Port:
Serial console port is located inside the box at CON1. You
need to use console cable (CBL-F10M9-20) to access it
Serial Console RS-232
1
2
1
3
5
9
7
10
9
To use the serial console port, you need to open the metal
case of Matrix-522 and the CON1 connector is near the
reset button and LEDs. User can also redirect the serial
console port to any one of the serial port by command /
Port 1~2
setconsole. Please use setconsole —help for the usage.
Digital I/O Port ( DB25 Female)
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
N/C
2
N/C
Note:
RXD
4
N/C
1.
VCC3: 3.3 VDC output
2.
VCC5: 5 VDC output
TXD
6
N/C
3.
GND: Digital Ground
N/C
8
N/C
GND
10
N/C
Function
Pin No.
Function
DIO0
14
DIO13
DIO1
15
DIO14
DIO2
16
DIO15
DIO3
17
DIO16
DIO4
18
DIO17
DIO5
19
DIO18
DIO6
20
DIO19
DIO7
21
DIO20
DIO8
22
GND
DIO9
23
GND
DIO10
24
VCC3
DIO11
25
VCC5
DIO12