Custom Crimp D100H SERIES Посібник оператора - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник оператора для Обтискний інструмент Custom Crimp D100H SERIES. Custom Crimp D100H SERIES 13 сторінок. Hydraulic hose crimper
Також для Custom Crimp D100H SERIES: Посібник оператора (12 сторінок)

Друкувати сторінку

Custom Crimp D100H SERIES Посібник оператора

CRIMPING WITH STANDARD DIES

• Place the ﬂ at pressure plate in the bottom ﬂ ange and select

the correct die set for the combination of hose and ﬁ tting to be

crimped. Refer to the hose and ﬁ tting manufacturer's recommen-

dation for the correct die set to use.

• Lubricate the contact surfaces of the die ﬁ ngers and compres-

sion cone thoroughly with the die lubricant furnished with the

crimper (EZCRIMP M).

Failure to lubricate the contact surfaces with the proper lubri-

cant will cause the dies to seize in the compression cone.

• Set the Micro-Crimp Adjuster to the setting recommended by the

hose and ﬁ tting manufacturer for the combination of hose and ﬁ t-

ting being crimped.

NOTE: The Metric Micro-Crimp Adjuster is a direct reading

micrometer. Add the setting on the micrometer to the closed

diameter of the die set to obtain the ﬁ nished crimp diameter. For

example: With a 39mm die and the Micro-Crimp Adjuster set at

3 the ﬁ nished crimp diameter would be 42mm

• Place the Compression Ring over the die set and align the ﬁ tting

to the correct position.

• Slowly bring the Pusher in contact with the Compression Ring

until the hose and ﬁ tting are held in position with a very light pres-

sure. Recheck the ﬁ tting for correct alignment.

• Continue to apply pressure until the white circumferential line on

the Micro-Crimp Sight Button just appears above the Micro-Crimp

Adjuster (See illustration on P 5) or the electric power unit shuts

oﬀ for the 101S crimper.

• Check the diameter of the ﬁ nished crimp to be certain that it is

within the speciﬁ cations of the hose and ﬁ tting manufacturer.

NOTE: Each die set has a limited range of diameters for which

it can be used. A "Rule of Thumb" is that if you can see the

notches on the die ﬁ ngers under the Compression Ring prior to

crimping, you must select a larger die

size.

Page