Custom Crimp D160-T420 Series Посібник оператора - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник оператора для Обтискний інструмент Custom Crimp D160-T420 Series. Custom Crimp D160-T420 Series 10 сторінок. Hydraulic hose crimper
Друкувати сторінку
Make certain that the cone
base is clean and lubricated
prior to inserting the die set.
Place the lubricated die set
squarely in the cone base as
shown.
Slide the Pusher onto the stud on
the ram and press the start stop
switch or apply pressure to the
D160 Series. The crimper will
shut off when the crimp cycle is
complete.
Micrometer Setting Example: With a 30mm die and the micrometer set at 3.0mm, the fi nal crimp
diameter will be 33mm (30mm + 3mm)
Select the correct die set for
the hose-fi tting combination
from the manufacturers
specifi cation sheet
Align the fi tting in the die set
according to the hose and
fi tting manufacturers recom-
mendation.
When the crimp is complete in the
D160 series, a white indicator line
will be visible.
Lubricate the die fi ngers with
the moly disulfi de grease
furnished with the crimper.
Place the Compression Plate
over the die set and compress
the die set by hand to hold the
hose and fi tting in place.
micrometer setting
example.
Check the fi nal crimp
diameter to confi rm that
it is within manufacturers
specifi cations.
See
6