Custom Crimp CC4-50 Посібник оператора - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник оператора для Промислове обладнання Custom Crimp CC4-50. Custom Crimp CC4-50 17 сторінок.

DIE SET UP AND INSTALLATION

Page

Industrial and Hydraulic hose dies are available for this crimper.

Industrial Dies are inserted directly into the Master Dies and

hydraulic dies require an intermediate die. Hydraulic Dies are

available with an 80mm, 84mm, 99mm and 130mm O.D.

The I.D. of the intermediate die must match the O.D. of the

hydraulic die or accurate crimps are not possible.

INDUSTRIAL DIE INSTALLATION

INTERMEDIATE ADAPTER DIE INSTALLATION

Turn on the crimper at the master power switch (See AccuCrimp

Controller Instructions) and go to Manual mode.

Insert the die removal tool in the release hole to release the

retaining spring and attach either an Intermediate Adapter Die or a

Hydraulic Die to the Master Die. the numbers stamped on the face

of the die should face the operator.

Mount all 8 dies in a similar manner.

If Industrial Dies are being used, proceed to the AccuCrimp

Operating instructions and set up the crimper for the correct crimp

diameter.

If Hydraulic Dies are being used, see Hydraulic Die Installation

instructions.