Custom Dynamics PROBEAM PB-SS-KIT2 Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Аксесуари для мотоциклів Custom Dynamics PROBEAM PB-SS-KIT2. Custom Dynamics PROBEAM PB-SS-KIT2 3 сторінки.

Друкувати сторінку

Installation:

1. Remove the existing lens from turn signal hous-

ing.

2. Remove existing bulb from turn signal housing.

3. Remove any corrosion or dielectric grease from

the socket to insure the socket contacts are

clean.

4. Using a small flat blade screwdriver, go around

the perimeter of the reflector and slightly push

the black gasket into the housing to allow prop-

er clearance of the new LED turn signal (Refer to

Figure 1).

5. Confirm the proper orientation of the socket

base and insert the base into the socket. If it

seems hard to twist the base in the socket or

hard to remove, it is probably orientated the

wrong way.

6. Twist the LED turn signal a few rotations to coil

wire from the turn signal to the socket base. In-

sert LED turn signal into housing and install new

lens.

7. Insure the notch in the lens gasket is aligned

with the notch in the lens. (Refer to Figure 2.)

8. Install the lens on the turn signal housing with

the lens notch located at the bottom of the turn sig-

nal housing. (Refer to Figure 3.) Caution: If there is a

gap between the lens and the housing, water will

leak into the unit and cause damage, be sure the

lens is full seated.

Check operation of turn signals in all modes

Questions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

Installation Instructions - Page 2

10-2018