Altronix NetWaySP1P Посібник з монтажу

Переглянути онлайн або завантажити pdf Посібник з монтажу для Конвертер мультимедіа Altronix NetWaySP1P. Altronix NetWaySP1P 4 сторінки. Powered media converter/injector
Також для Altronix NetWaySP1P: Посібник з монтажу (4 сторінок), Посібник з монтажу (4 сторінок), Посібник з монтажу (4 сторінок)

Друкувати сторінку
Altronix NetWaySP1P Посібник з монтажу
NetWaySP1P
Powered Media Converter/Injector
Altronix NetWaySP1P powered media converter/injector converts 10/100/1000 Mbps
ethernet to Fiber (1000Base-X/SX/LX) and provides PoE.
Agency Listings:
• CE approved.
Input:
Fiber Port:
• One (1) 1Gb SFP port.
• Use with SFP module 1000Base-X (1Gb),
compliant to Class 1 laser product
(not included).
Ethernet:
• IEEE 802.3at (30W) compliant.
• Wire type: 4-pair CAT5e and higher.
• Connectivity: RJ45, auto-crossover.
Unit is powered via 24VDC-56VDC. NetWaySP1P is not intended to be connected to outside
plant leads and should be installed indoors within the protected premises.
1. Mount NetWaySP1P in desired location utilizing the mounting hole (Fig. 1a, pg. 1).
Use a proper fastener and/or wall anchor when securing NetWaySP1P with screw through
its mounting hole to the wall.
2. Connect 24VDC-56VDC power source to terminals marked [24-56VDC -- Input +].
Terminals accomodate up to 12 AWG wires.
3. Connect structured cable from port marked [PoE+ Output] on NetWaySP1P to a
PoE device (Fig. 2, pg. 2).
4. Connect fiber optic cable to a fiber SFP module. Connect the module to the port marked
[SFP] on the NetWaySP1P. Connect the other end of fiber cable to an SFP module of a
remote device. SFP LED will illuminate indicating data connection (Fig. 2, pg. 2).
Fig. 1
NetWaySP1P
Media Converter/Injector
Input:
Output: IEEE 802.3at (30W) and
24-56VDC
PoE+
-- Input +
Output
NetWaySP1P

Installation Instructions:

Fig. 1a
Made in U.S.A.
www.altronix.com
24VDC–56VDC
IEEE 802.3af (15.4W)
compliant.
Fiber
PoE
SFP
Signal
Overview:
Features:
Ethernet
• Speed: 10/100/1000Mbps.
• Distance: up to 100m.
LED Indicators:
• PoE Green LED: Indicates PoE present
(unit is powered on).
• Fiber Signal Green LED:
Indicates SFP connection.
Environmental:
• Refer to Environmental Conditions on page 3.
Dimensions (W x L x H approx.):
3.375" x 3.8" x 1"
(85.7mm x 96.52mm x 25.4mm).
Structured
24VDC to
Cable to
56VDC
Input
PoE Device

Installation Guide

:
(cont'd)
SFP LED
Indicates
data connection
One (1) Gb
SFP port
for Fiber
Rev. 053117
- 1 -