Artison LRS-W Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Спікери Artison LRS-W. Artison LRS-W 8 сторінок. Surround / in-wall surround

This section will guide you through the installation of the In Wall / In Ceiling Artison Surrounds.

Please refer to the diagrams on the opposite page for help.

1. Positioning Guidelines

a. The LRS-IW was designed to fit between 16" O.C. Studs, the cutout is a simple

rectangle 13.5" W x 9.5" H.

b. The LRS-IW should be mounted behind, beside, or above the primary seating area.

c. When wall mounting, the LRS-IW should be mounted at a height ¾ of the total wall

height (i.e. for a 10' high wall, mount LRS-IW 7.5' high).

d. When ceiling mounting the LRS-IW pair should be mounted at least 6-8 ft. apart

horizontally.

e. Keep the LRS-IW at least two feet away from any corner when possible.

f. NOTE: These are only recommendations; your specific room application will

determine the final height and placement of the surround speaker mounting.

2. Artison LRS-IW Surrounds are marked Left or Right on the back of the speaker. To ensure

the correct dipole sound staging, keep the corresponding speaker on the correct side of

the listening area. Left or Right is determined when facing the display screen.

3. Using the supplied cutout template and pencil, mark the cutout lines. Before cutting into

the wall, check the intended speaker location for any obstruction that may not be visible,

this should be done with a "stud-finder" type of device.

4. Connect the speaker wire to the corresponding positive (Red) and negative (Black)

speaker terminals.

5. Install in the opening and using a #2 Philips Screwdriver tighten the dog-leg style clamps.

Be careful not to over tighten them as it may damage the wall surface or speaker.

6. Install the LRS-IW Grilles. See Figure 4.

LRS-IW