Artison Sketch LCR DualMono MK 2 Короткий довідник - Сторінка 2
Переглянути онлайн або завантажити pdf Короткий довідник для Спікери Artison Sketch LCR DualMono MK 2. Artison Sketch LCR DualMono MK 2 4 сторінки.
Також для Artison Sketch LCR DualMono MK 2: Посібник з монтажу (16 сторінок), Короткий довідник (4 сторінок), Посібник з монтажу (4 сторінок)
Друкувати сторінку
3-Channel Wiring
The diagram below shows connections to a multichannel amplifier with three separate front channels (left, right, and center). In
this scenario, the center channel is nominal 6 ohms in the parallel configuration shown.
Stage Tweeter
Right
Speaker
2-Channel Wiring (Stereo)
The diagram below shows connections to a stereo amplifier with two separate channels (left and right). In this scenario, each
channel is nominal 10 ohm.
Stage Tweeter
Right
Speaker
Making Connections
The steps below describe how to connect a wire to the terminals on the rear of the speaker.
1. Strip insulation so there is
2. Press down on the top of the round spring loaded terminal jack until the holes in the side of terminal align.
3. Insert wire into opening and release the terminal jack. The spring loaded terminal will now hold the wire securely in place.
4. Tug on the wire to ensure a secure connection.
HELPFUL!
– #16 AWG is recommended for wire lengths up to 50 feet.
– #14 AWG is recommended if wire length is longer than 50 feet but less than 100 feet.
– #12 AWG is recommended if wire length is longer than 100 feet but less than 300 feet
– #12 AWG is the maximum wire gauge that will fit into the push pin terminals.
M-LCRDM-MK2 | 009-1625-01 | 190826
Copyright 2018 Savant Systems, LLC
Rear View
of Speakers
ON
OFF
+
+
—
Right
Center
Rear View
of Speakers
ON
OFF
+
—
Right
3/8
inch (9mm) of exposed bare wire.
Stage Tweeter
ON
OFF
Left
Speaker
Amplifier
+
—
—
Channels
Left
Stage Tweeter
ON
OFF
Left
Speaker
Amplifier
+
—
Channels
Left
2
of
4
2231 Meridian Blvd #1, Minden Nevada 89423
www.savant.com/artisonspeakers
| 775.783.4770