DK-TEC LS6000C Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа DK-TEC LS6000C. DK-TEC LS6000C 14 сторінок. Wood splitters 6 and 8 tons
Друкувати сторінкуKeep the woodcutter clean at all times.
Change the hydraulic oil after approximately 500 hours of operation. Use regular hydraulic oil.
Lubricate the cleaver with grease each time the machine is to be used - this will increase the
life of the cleaver. When replacing parts on the machine, only original spare parts may be used.
Regularly check the tightness and strength of hydraulic hoses and hose connections.
WARNING! Only add oil when the clevis head
is in the engaged position.
The machine may only be used for splitting firewood. Split material must have the following
dimensions:
•
Minimum diameter: 80 mm
•
Maximum diameter: 350 mm
•
Only splitting wood along the grain of the wood is permitted.
•
The pressed piece of wood can be released by lightly tapping the wood.
•
It is forbidden to cut the split tree free!
1. Start the engine by pressing the green button. WARNING! Make sure the direction of
motor rotation matches the 400 V setting! Stop the engine by pressing the red button.
2. Keep the supply cable as short as possible for the 230 V models and choose as large a
cross-section as possible.
3. When the temperature is low, allow the clover to idle for about 15 minutes before use to allow
the oil to warm to a suitable temperature.
4. Place the material to be split on the splitting table and hold it firmly using the control handles.
5. The splitting starts by pressing both handle down.
6. During splitting, the wedge usually holds the wood in the splitting position.
Service and treatment
Field of application
Application
9