DK-TEC SAVCDH Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Газонокосарка DK-TEC SAVCDH. DK-TEC SAVCDH 15 сторінок. Flail mower
Друкувати сторінку
Connection to
tractor
Behavior on the road, steering and braking capacity are affected when the machine is connected to
the tractor. The front axle of the tractor lights up in relation to the weight attached to the coupling to
the lifting arm: the load on the front axle must be at least 20% of the weight of the empty tractor.
Before connecting the machine to the 3-point connection, the tractor's safety device must be
positioned to make it impossible for unwanted and/or casual lifting and lowering. The three-point
connection of the tractor and the machine must match or be adjusted.
In the rod zone of the tractor's rear lights, there is a risk of injury due to pinching and cutting
points.
Do not use the external control to lift the machine.
In the transport position, the side stop of the rod and the control level of the lift are
blocked. Connection
WARNING
Always use the recommended safety equipment (safety shoes, work gloves and hearing protection)
Mounting the flail mower:
The machine is equipped with bolts for the tractor's three-point connection. Connecting the
machine to the tractor is done as follows:
•
Approach the tractor to allow the lifting beams to coincide with the 3 point joint and connect
them with the relevant bolts
WARNING
Insert safety plugs into the holes. Make sure they are blocked.
•
Connect the 3-point link to the upper link and adjust it to position the machine parallel to the
ground. Check that the blades or hammers on the rotor shaft, when the machine is on the
ground, do not touch the ground during rotation.
•
To prevent the knives or hammers from touching the ground, it is necessary to regulate the
height of the rear roller via the blocking screw which is inserted into the selected hole.
WARNING
Place the tractor on a level surface. Before adjusting the flail mower, stop the engine and lock the
brake.
Hydraulic connection of lateral displacement
•
Turn off the engine (if on), apply the parking brake and remove the ignition key from the ignition
panel.
•
Check that there is no pressure in the tractor's hydraulic system.
•
Connect the quick-coupling hydraulic pipes to the tractor after checking that all joints are
clean and in very good condition.
•
Pressurize the hydraulic system. Check that it is not leaking and that the connection is correct.
•
When the flail mower is finished operating, the hydraulic pipes released from the tractor must
be fixed in the corresponding supports for this purpose.
3. Operation
9