Altusen KH-88 Швидкий старт Quide

Переглянути онлайн або завантажити pdf Швидкий старт Quide для Перемикач Altusen KH-88. Altusen KH-88 2 сторінки.

Друкувати сторінку

High Density KVM Switch (KH88) QUICK START GUIDE

Package Contents

The complete KH88 package consists of:

• KH88 KVM Switch

• Firmware Upgrade Cable

• Power Cord

• Rack Mounting Kit

• Quick Start Guide

• Warranty Registration Card

• User Manual

NOTE :

Check to make sure that each item in the above list is included in your package.

If any item is missing or was damaged in shipment, please contact your dealer.

Read this manual thoroughly.

Follow the installation and operation procedures carefully to prevent damage to the KH88 unit and any

connected devices.

System Requirements

This section details the required hardware components for successful installation and use

of the KH88

Console

• A VGA, SVGA or Multisync monitor capable of the highest resolution that you plan to use on any

computer in the installation

• A PS/2 style mouse

• A PS/2 style keyboard

Computers

To use and access the KH88 successfully, your computer requires the following:

• A VGA, SVGA or Multisync card.

• A 6 pin mini-DIN (PS/2 style) mouse port. (The KH88 does not support serial mice)

• Either a 6-pin mini-DIN (PS/2 Style) keyboard port with +5V DC on pin 4 and Ground on pin

3,or a 5-pin DIN (AT Style) keyboard port with +5V DC on pin 5 and ground on pin 4 (PS/2 to

AT adapter required).

The KH88 Unit ( Front View )

1. Port Selection Switches

2. Port LEDs

3. Reset Switch

4. Power LED

The KH88 Unit ( Rear View )

1. Power Socket

4. Console Port Section

2. Power Switch

5. CPU Port Section

3. Firmware Upgrade Section

Hardware Installation

To prevent damage to your equipment, please do the following before you begin installation:

-Make sure that power to all the devices you plan to connect are turned off.

-Make sure that all devices on the installation are properly grounded. Consult your

dealer for the technical details if necessary.

Hardware Installation

1. Plug your keyboard, mouse, and monitor into the unitʼs Console Ports.

2. Use a KVM cable to connect any available CPU port to the keyboard, video and mouse

ports of the computer you are installing.

3. Plug the power cable into the KH88 power socket, and then plug the power cable into an

AC power source.

4. Turn on the power to the computers

STOP

Hardware Installation

Cascading

To control even more computers, up to eight additional KH88 units can be cascaded from the CPU

ports of the First Stage unit.

The cascaded KH88 that connect back to the First Stage unit are considered Second Stage units.

As many as 64 computers can be controlled in a complete two stage installation.

Hardware Installation