CustomWorks ENFORCER G6 Інструкція з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшкова машинка на колесах CustomWorks ENFORCER G6. CustomWorks ENFORCER G6 19 сторінок.
Друкувати сторінкуMounting Low DF Nose to Cage
- In the hole shown in the above image marked with
the "X", use (1) 5253 screw to fasten the body panel
to the Front Down Tubes.
5254 X2
X
- Re-attach the Front Bumper using (2) 5254 Screws in the remaining holes. Optional front wing mounts
will attach using the screws noted with the "X".
Top Wing:
Assemble the wing kit using the instructions provieded inside the wing kit. Mount the wing to
the car and it should look just like the car shown below.
X
5253
X
Mounting High DF Nose to Cage
O O
- In the hole shown in the above image marked with
the "X", use (1) 5253 screw to fasten the body panel
to the Front Down Tubes.
- Use a .113" drill or smaller thru the (2) remaining
holes in the Front Down Tube to make the holes
marked by the "O".
5254 X2
X
X
5253
X