Alula RE934ZT Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Комп'ютерне обладнання Alula RE934ZT. Alula RE934ZT 4 сторінки. Translator and zwave expansion card
Також для Alula RE934ZT: Посібник (4 сторінок)
Друкувати сторінкуHoneywell & 2GIG Sensor Enrollment
Note: Honeywell Smoke and CO sensor packets are indistinguishable from one another.
Each time RF enrollment mode is enabled/re-enabled:
• Smoke sensors must be enrolled before the sensor types listed in step 5 below.
• CO sensors must be enrolled after the sensor types listed in step 5 below.
1. Ensure panel is not in RF enrollment mode.
2. Remove batteries from all Motion (PIR) sensors.
DO NOT PROCEED UNTIL YOU HAVE FINISHED STEPS 1 AND 2
STOP
3. Place panel in RF Enrollment mode.
4. Enroll All Smoke Sensors First - Press and hold the test button until the sensor beeps,
continue holding for two seconds, then release. Wait for 30 seconds. If the sensor does
not enroll, try holding the test button longer before releasing.
5. Enroll the following sensor types as instructed,
• Panic Buttons - Press and hold the panic button until the panel beeps confirming
enrollment (this may take up to 20 seconds). If the panic button does not enroll,
wait 30 seconds before retrying.
• Key Fobs - Press and hold the LOCK/ON/AWAY button until the panel beeps
confirming enrollment. If the fob LED turns off before the panel enrolls the fob,
press and hold the LOCK/ON/AWAY button again.
Note: Pressing any other button may cause the fob to enroll as the wrong
device type.
• Tilt Sensors - Ensure the garage door is closed. Remove the sensor cover to
tamper the device. With the cover removed, open the garage door, then close the
garage door and re-install the cover.
• Door/Window Sensors - Cycle the contact three times (Open-Closed-Open or
Closed-Open-Closed), allowing several seconds between each change.
• Glass Break/Shock/Environmental - Cycle the tamper switch three times allowing
several seconds between each change.
Note: Honeywell sensors will enroll as a Generic device type using this
method. Sensor settings, active arming levels, alarm/siren type, etc. will need
to be configured as desired using the Installer App or dealer portal.
• Motion Sensors (PIR) with Tamper - Press and hold the tamper switch and insert
the battery.
• Motion Sensors (PIR) without Tamper - Insert the battery.
6. Pin Pad (PAD1 - 2GIG Only) - Press buttons 1 and 3 at the same time.
Using 2GIG Pin Pad:
• Disarm by entering a valid user pin code on the number pad
• Arm using the Stay/Away buttons
• Arm to Night using the * button
• Arm or disarm silently by pressing # followed by an arming button or pin code
• Trigger a Fire/Police Alarm by holding the Fire or Police button until the LED blinks
7. Enroll All CO Sensors Last - Press and hold the test button until the sensor beeps,
continue holding for two seconds, then release. Wait for 30 seconds. If the sensor does
not enroll, try holding the test button longer before releasing.