Aluminess Products RAIN GUTTER MOUNTED ROOF RACK Інструкція з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Автомобільні аксесуари Aluminess Products RAIN GUTTER MOUNTED ROOF RACK. Aluminess Products RAIN GUTTER MOUNTED ROOF RACK 2 сторінки.
Друкувати сторінкуRAIN GUTTER MOUNTED ROOF RACK INSTALLATION INSTRUCTIONS
Ford, Dodge, and Chevy Van, OEM
Roof
Please read before beginning
•
Stainless steel hardware may bind together
when tightening—It is recommended that you
apply an anti-seize assembly lubricant to the
threads of each bolt before assembly
•
This installation requires two people
Required tools
•
Standard wrench set
•
Allen wrench set
•
Adjustable crescent wrench
•
(Optional) Leveling tool
Assembly hardware
•
70050 – ½" x 1" Stainless Steel washer
•
70024 – 3/8"-16 Stainless steel nuts with nylon locking insert
•
70030 – 3/8"-16 x Flat head socket cap screw
Included hardware
•
300174 – Roof rack mounting clips
•
70072 – 3/8"-16 x 1 ½" SS Hex Head Bolt
•
70028 – 3/8" ID Stainless steel washer
•
70024 – 3/8"-16 Stainless steel nuts with nylon locking insert
•
Antiseize Packet, 2g
Assembly instructions
1. (Already assembled) Lift up one side of the roof rack and put
the countersink bolts (70030) through the countersunk
horizontal hole in the roof rag leg, facing outwards away from
the roof. Apply anti-seize to threads and install and tighten
down the nylon locking nuts (70024), make sure they are
securely fastened. Note: Make sure the anti seize is applied
after inserting the bolt so it does not get on the counter sink
surface of the bolt or plate.
2. With someone assisting you, lift up the roof rack and rest it on
the van's roof, with the mounting legs sitting in the rain gutters.
Make sure the rear cross bar of the roof rack would be even
with the back of the van gutter. NOTE:—the narrow end of the
roof rack should be towards the REAR of the vehicle
3. If the mounting legs do not fit inside the rain gutters, place a large adjustable wrench on the leg's horizontal lip
and push down or up to bend the legs in or out
4. Place the roof rack mounting clips on the bolts (70030) , as pictured, and insert the longer bolt ( 70031) into the
vertical hole facing upwards with a washer (70180) on the bolt head
5. Put washers (700180) on the outsides of the bolts and loosely thread on the supplied nylon locking nuts (70024)
6. Repeat this process for each of the legs that have bolt holes, making sure not to tighten the mounting clips yet
7. Make sure that the rack is in place and level, then proceed by tightening down all of the fasteners until the rack is
secured firmly—do not over-tighten. The mounting clip may deform.
Aluminess Products Inc
10943 Wheatlands Ave
2 per leg
1 per leg
1 per leg
Quantity
1 per leg
1 per leg
3 per leg
2 per leg
1
Santee, CA 92071
619-449-9930