DLA DLA56 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Двигун DLA DLA56. DLA DLA56 7 сторінок. Toplevel gasoline engine
Також для DLA DLA56: Посібник користувача (5 сторінок)
Друкувати сторінку
• The propeller blades must be of the same length.
Installation： ： ： ：
• You must use a drill press to drill your propeller from the rear.
• A drill guide is recommended, but the propeller washer can be used as a drill
template. (Fix the propeller washer onto the propeller in the center-bore
using a bolt and nut.)
• keep your propeller balanced.
Engine starting procedure
1. Fill the tank with fresh filtered fuel.
2. Insure that your receiver and ignition batteries are charged, your receiver
and transmitter are on. , and that your throttle is set to low.
3. Close the choke and turn on the ignition switch.
4. Rubber stick is recommend to start the engine.
5. Begin flipping the prop through its compression stroke until the engine fires.
6. Wait for the propeller to stop spinning, turn off the ignition, and open the
choke(s)
7. Switch the ignition back on and flip the propeller again until the engine
starts
8. warm up the engine for 15 or 20 seconds before advancing the throttle.
Carburetor Tuning and Care
The use of a tachometer is highly recommended. And, again, never adjust the
needles while the engine is running!
Tuning
1. Using the tachometer tune the engine for maximum power with the high
needle (H).
2. Using the tachometer again: richen the high needle (H) until the motor runs
100-200 RPM
less than the maximum RPM. Now you should richen slightly on the high
needle (H).
Keep the engine run at idle for 60 seconds. Insure that the idle RPM to be
constant. If the low needle (L) is too rich,it may happen that idle RPM drops
until the engine stops;. Lean the low needle (L) until a constant idle RPM is
achieved.
Check the transition with a quick throttle advance. It should sound like it is
making quick steady power.
Care:
Your carburetor screen will need to be cleaned with clean gasoline and blow
off with compressed air after every flight. Check the choke and throttle plates
for tightness.