DLab SK-L330-Pro Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Лабораторне обладнання DLab SK-L330-Pro. DLab SK-L330-Pro 11 сторінок. Lcd digital shaker
Друкувати сторінку
2.5 Replacement of photoelectronic switch
2.6 Replacement of power board component
2.7 Replacement of motor drive board
Step 1:
Unplug the cable marked by red
circles on MS-Motro Board, as shown
in figure;
Step 2:
When
photoelectronic switch, the Shaft
Encoder on the motor must match
with photoelectronic switch. When
motor is turning, Shaft Encoder
cannot be frictional contact with
Photoelectronic. After Shaft Encoder
is in place, lock it with screws.
As shown in the left figure, unplug
the connector marked by blue
circles, remove the 8 screws marked
by red circle and keep them well,
then replace new power board
component.
As shown in the left figure, unplug
connectors marked by blue circles,
remove the 4 screws marked by red
circles and keep them well, then
replace a new motor drive board.
7
you
replaced
new