dlb AIJGO-60 Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вимірювальні прилади dlb AIJGO-60. dlb AIJGO-60 10 сторінок. Walking tester

STORING MEASUREMENT RESULTS

You can store the measured results by long pressing the „MODE" button. After this a

notification can be seen on the display for 3 seconds. If there is still an empty space in

the measurement list, a text similar to the following appears on the display:

MIN/MAX STORED

LIST POS: x

The value „x" indicates the position in the measurement list where the measured

peak values are stored. This list can hold up to 20 measurements. When it is full, it is

not possible to store any more measurement results and the following message is

displayed after a long press of the „MODE" button:

LIST FULL

When the list is full, it is only possible to store new measurement results after deleting

the list, which can only be done by a computer.

MANAGEMENT OF MEASUREMENT RESULTS ON

COMPUTER

An AIJGO-60 can be connected to a computer with a USB-A – mini USB-B cable.

For the management of measurement results on a computer, you need to install the

driver program supplied on pendrive with the device, which assigns a virtual serial

port to the tester. To do this, run the „CDM v2.08.30 WHQL Certified.exe" application

as administrator (Right mouse button -> Run as administrator). If the installation is

done, run the supplied terminal program (termite-3.1.exe). The program is running

immediately after the installation is done, later you can use the shortcut in the Start

menu (look for "Termite").