ARTRED AR-55 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Скруббер ARTRED AR-55. ARTRED AR-55 11 сторінок. Scrubber-dryer

Друкувати сторінку

Quarterly Maintenance

Examine the abrasion conditions of the carbon brush of drive motor (drive
model), vacuum motor and brush motor every 250 hours. When the abrasion
length of the carbon brush is within 10mm, the carbon brush needs to be
replaced. If it is required to deliver the machine for maintenance, please contact
with the authorized service center.
Warning:
Electric shock hazard. Please firstly disconnect the battery wring
before maintaining the machine.

Machine Transport

When transporting the machine with truck or trailer, please ensure to following
the following binding procedure:
1. Lift up the brush head to the transport position
2. Use the suggested handling apron to load and unload the machine.
3. Lean the front of the machine closely against the front part of the truck or
trailer. When the machine is placed properly, lower down the brush head and
turn the key to the close position.
4. Place blocks behind each driving wheel to prevent the machine from sliding.
5. Use the rope to fix the top of the machine to prevent titling. You must install
bracket on the sweeping board of the truck or trailer. For safety: when
transporting the machine, please use the suggested handling apron

Machine Storage

when
1. Please charge the battery before storage. Do not store the battery with
the power running out.
2. Drain and flush thoroughly the bottom of teh water tank.
3. Store the machine in a dry palce and the brush head shall be kept in the
rising position.
4. Open the cover of the waste water tank. Note: Don not let the
handling the machine from the truck or trailer and use the rope to fix the
machine on the sweeping board.
machine subject to the rain and store it indoor.
5. If the machine is stored in a cold environment, please indeed drain all liquid
in the machine.

Troubleshooting

Problem
Reason
The battery has no power
The machine
can
not
be
The battery fails
operated
The battery wiring is loose
The main fuse blows out
The brush head rises up from the ground
The
brush
motor
does
The battery coulombmeter is locked and not
started
not work
The breaker of the brush motor circuit triggers
blackout
The brush (upper/lower) switch fails
The carbon brush of the motor wears
The
vacuum
The squeegee rises up from the ground
motor
does
The fuse of the vacuum motor blows out
not work
The vacuum motor or wiring fails
The carbon brush of the motor is worn
A little or no
The filter or solution pipe of the clean water
tank is blocked
water
flows
out
The speed of the flow control knob is set too
low
The screw of the control knob is loosened
The waste water tank is full
The
waste
water
The water-absorbing adhesive tape is worn
recovery rate
The water suction pipe is blocked
is low
The sealing strip of the waste water tank is
damaged
The vacuum motor fails
The battery has flaws
The running
time shortens
The battery charging fails
Solution
Charge the battery
Replace the battery
Fasten the battery wiring
Replace the fuse
Lower down the brush head
Charge the battery
Reset the button of the breaker of the
brush circuit
Please contact with the service center
Please contact with the service center
Lower down the squeegee
Replace the fuse
Please contact with the service center
Please contact with the service center
Clean the filter of the clean water tank
Adjust the water control knob
Lubricate the knob and then fasten the
screw
Drain the waste water tank
Replace the water-absorbing adhesive tape
Remove the blocked scraps
Replace the sealing stripe
Please contact with the service center
Replace the battery
Repair or replace the charger