ALUZ ZIZA Посібник - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник для Освітлювальне обладнання ALUZ ZIZA. ALUZ ZIZA 14 сторінок. Led tape

TROUBLESHOOTING TIPS

• Do not reset the breaker multiple times.

• If the unit is overloaded, the breaker will trip, shutting off the driver

and lighting.

• If the breaker reset button has been held down by hand or any type of

pressure, such as duct tape, or if the breaker has been reset multiple

times without troubleshooting, the unit will:

- Burn the driver bobbin.

- Burn the thermal or magnetic breaker.

- Burn the driver lead wires due to high amperage caused by overload.

- Short circuit in line which will not allow the breaker to reset.

- Damage the lighting.

Turn off power before beginning. Verify power is off by using a non-

contact circuit tester (by others).

Check lightstrip for damage, such as cuts, punctures, twisting, or

crushing. If there is excessive damage to the lightstrip, the lightstrip

must be replaced.

Check the run for any particles that may cause a short. Check the

end cap, power connector, and lightstrip for any metal flakes or

shavings. Clear the run of any shavings or particles if present, then

perform a continuity test to conﬁ rm the short has been eliminated.

Check lightstrip cuts to ensure they are clean. Frayed, split, or

sloppily cut lightstrip can cause the positive and negative contacts

to touch, causing a short.

Check connections in the line. Ensure all splice connections are

secure and properly sealed with shrink tube and silicone for

outdoor applications. Ensure that wiring is not bent past the

permitted wiring bend radius (1.5").

Check the run for any water inside end cap, power connector, and

lightstrip. If water or condensation is has caused damage, the

lightstrip must be replaced.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

A8 Series | LED Tape

ZIZA Tape

(A8-ZIZA-TAPE)

866.ALUZ.LTG | 714.535.7900

Page 12 of 13

Troubleshooting

Installation Instructions

8 / 11 / 2023 / Rev 2