ALUZ ZIZA Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Освітлювальне обладнання ALUZ ZIZA. ALUZ ZIZA 14 сторінок. Led tape
Друкувати сторінку1
Measure area where lightstrip will be installed. Use a laser line to
create a reference line along installation area, ensuring consistent
alignment of mounting clips. Mark location where each mounting
clip will be installed along reference line.
2
Remove adhesive backing from lightstrip and stick in place along
reference line, ensuring lightstrip is securely mounted and free of
twists, tangles, creases, bumps, or overlaps.
3
For Dry Location applications, only use the mounting clip with the
flat side facing down.
4
Use 1 mounting clip every 6", rounded up. Use 1 mounting clip every
4", rounded up if application is downward facing, outward facing,
or vertically mounted. Lay mounting clips and pre-drill using an
appropriate drill bit for surface material and screw size.
Recommendation: 8/32 x 1" screw.
-
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | LED Tape
ZIZA Tape
(A8-ZIZA-TAPE)
6"
4"
866.ALUZ.LTG | 714.535.7900
5
Screw mounting clips to surface, securing lightstrip to surface.
Note: Do not install clips over LED diodes.
-
6
Always use a mounting clip at the very beginning and very end of
each run.
7
If applicable, connect disconnects between luminaires or solder
connectors using the steps on Application Guidelines.
8
Perform a continuity test before connecting to power source.
Refer to Continuity Test for details.
Page 7 of 13
Mounting Lightstrip
(Dry Location Mounting Clips)
8/32
Installation Instructions
8 / 11 / 2023 / Rev 2