Alva GHP16 Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Газовий обігрівач Alva GHP16. Alva GHP16 17 сторінок.

Remove all packaging materials before assembling the patio

heater.

Before Assembly:

•

Please read all instructions thoroughly before proceeding

with the appliance assembly.

•

Find a large clean area in which to assemble the patio

heater.

•

Please refer to the parts list and diagrams. (see page 7)

•

Assembly of the heater involves large components and it is

advisable to have two people to assemble the unit.

Fig.A

If you have bought a new gas cylinder, the cylinder needs to be

purged (emptied out), before it's first use. If it is not purged of air,

the heater will not work properly. This should happen at the gas

filling station when you fill up the cylinder. Always check this with

your gas supplier.

Before removing this heater from the packaging, read this

manual in full and make sure that it is what you want /need.

Remove the heater from the packaging

Check if the nose cone sealing washer is in place, secure

and in good condition. (Figure B)

The regulator goes directly into the cylinder valve. Always

ensure that the regulator is correctly and firmly fastened in

place. The use of any adaptors is illegal.

ASSEMBLY

This patio heater makes use of an

industrial cylinder (9kg ALVA cylin-

der recommended) with a 5/8" BSP

thread; horizontal exit valve.

The Bullnose regulator supplied

with the heater tightens to the left

hand side (anti-clockwise). (Figure

A).

HEATER SET UP