DLS DLS CA12 Як встановити та експлуатувати

Переглянути онлайн або завантажити pdf Як встановити та експлуатувати для Підсилювач DLS DLS CA12. DLS DLS CA12 8 сторінок. 500 watts mono amplifier
Також для DLS DLS CA12: Як встановити та експлуатувати (8 сторінок)

Друкувати сторінку
DLS DLS CA12 Як встановити та експлуатувати
How to install and
operate the
DLS CA12
500 Watts
mono amplifier
Welcome!
This owners manual is written in easy english and
uses a lot of drawings to simply the installation and
use of the above amplifier.
Your DLS amplifier must be installed correctly in or-
der to work well. This manual will show you how to
install the amplifier like a pro. Please read the entire
manual before beginning the installation.
Install the amplifier yourself if you feel confident with
our instructions and if you have the proper tools.
However if you feel unsure, turn over the installation
job to someone better suited to it.
Warranty Service
This amplifier is covered by warranty, depending on
the conditions in the country where it is sold. If the
amplifier is returned for service, please include the
original dated receipt with the product.
Technical Assistance
For technical assistance ask the shop where the
product was sold or the distributor in your very coun-
try.
You can always phone the DLS Helpdesk in Sweden
+ 46 31 84 00 60 or send an e-mail to [email protected].
Information can also be found on our WEB-site
www.dls.se
DLS Svenska AB
P.O. Box 13029
S-40251 Göteborg, Sweden
Tel: +46 31 840060
Fax: +46 31 844021
www.dls.se
Contents
Specifications................................
Features...................................
Installation................................
Trouble-shooting........................
Routing Wires............................
Power and Outputs.....................
Inputs and controls.....................
Input level control..........................
Crossovers..................................
Phase control.............................
Speaker wiring..............................
Testing..........................................
Professional tips..........................

Specifications

DLS CLASSIC
Number of channels
Power output:
R.M.S. output in 4 ohm (0,1% THD)
R.M.S. output in 2 ohm (0,4% THD)
R.M.S. output in 1 ohm (0,5% THD)
All above output power ratings at 13,8 Volt
Signal to noise ratio, A-weighted
Damping factor
Frequency response
Input impedance, low level
Input impedance, high level
Input sensitivity
RCA output
Phase control 0-180 degrees variable yes
Filter subsonic
Filter lowpass 12/24 dB slope
Power consumption, idle
Maximum current draw
Built-in fan cooling in bottom plate
Fuse
Dimensions (mm)
Dimensions (inch)
Weight
Approval of electromagnetic compatability according
to the EEC Directive 95/54/EC
E 13
Approval No: 022495
We follow a policy of continuous advancement in
development. For this reason all or part of specifications
& designs may be changed without prior notice.
1
2
2
2
3
3
3
4
5
5
5
6
6
6
7
CA12
1
1 x 220 W
1 x 400 W
1 x 500 W
>100 dB
>100
10 Hz - 35 kHz
10 kohm
100 ohm
0,25 - 5V
yes
15 - 150 Hz
50 - 500 Hz
0,8 A
80 A
yes
2 x 30A
67x295x250
2,63x11,6x9,84
3,8 kg (8,4 lb)