DLS CRUISE CRPP-2.6CX Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Автомобільна стереосистема DLS CRUISE CRPP-2.6CX. DLS CRUISE CRPP-2.6CX 12 сторінок.

Be careful when removing the panels and lids, so

there will be no marks.

When the door panel is loose, start with softly

lifting it straight up, to remove the panel.

There are several electric and mechanical

connectors on the backside of the panel.

Release the door lock cable.

Disconnect the window control panel, cables for

lights, speaker cable harness and any other

connections.

Remove door speaker

The door speakers are fixed with rivets.

Use a 4mm drill to remove the rivets. Make sure

all remains from the old rivets are removed from

the inside of the door.

Just drill enough to remove the top of the rivets.

Mount door speakers

Place the new DLS driver in the hole for the

speaker. DLS recommends using a rivet tool (not

included in CRPP-2.6CX) and rivets to safely

mount the driver. (Step 3 might be done several

times)

Connect the speaker harness

Start the assembly of the door panel.

Reconnect all wires harness.

Connect all plugs to the door cover, reconnect the

unlocking device, place the door cover from the

top, by the window seal and push it gently down.

Make sure the clips are in place and can engage.

Give the door panel a push by the hand to attach

to the clips. Mount and fasten all screws to the

correct places.