ACP RiderPro Посібник з експлуатації та монтажу - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з експлуатації та монтажу для Будівельна техніка ACP RiderPro. ACP RiderPro 17 сторінок. Motorcycle protection for acp sentry barrier tl-4 thriebeam system
Друкувати сторінку10 Maintenance
RiderPro is a low maintenance protection device.
Except for repairs due to impacts, it is recommended
that an annual inspection is undertaken to assess the
following:
•
Debris has not accumulated around the barrier
which may impede the function of the barrier;
•
Vegetation around the barrier is appropriately
maintained;
Nuisance impacts have not gone undetected;
•
and
End terminals are fitted to the ends of the
•
RiderPro system.
Table 1: Damage Assessment Guidelines
Type of Damage
The sum total of the damaged area does not exceed
180 cm
Damage to the
galvanized
coating on the
The sum total of the damaged exceeds 180cm
beams.
(0.5% of the total surface area) and no individual
Damage to the
beams.
Damage to the
mounting
brackets.
Damage to bolts.
Ref: IM 031 Rev 00
Date: 15/07/2021
Page 12/17
Description of the Damage
(0.5% of the total surface area) and no
2
individual damaged area exceeds 40cm
damaged area exceeds 40cm
The beam is dented, twisted or flattened.
There are nicks in any part of the beam.
The slots in the beam are distorted.
The bracket is bent, twisted or flattened.
The body of the bolt is distorted.
The thread of the bolt is damaged.
11 Repair
In the event of an impact, damage to the RiderPro
system is to be assessed in accordance with Table 1.
Typically, impacts with RiderPro will require
replacement of damaged sections of mounting
brackets and beams. It is also recommended the use
of new bolts where mounting brackets and beams
have been replaced.
Similar to the installation sequence, it is
recommended that the guidelines contained in
Section 8.0 be observed in the establishment of
traffic control and an unloading exclusion zone in
addition to investigation for underground services
and overhead obstructions.
An organic zinc rich paint is to be
applied to the repair area in two
.
2
2
The beam is to be replaced.
2
.
The beam is to be replaced.
The mounting bracket is to be
The bolt is to be replaced.
Action
coats.
replaced.
Property of
Margaritelli Ferroviaria S.p.A.
06135 Ponte San Giovanni - Italy