BluCube CXC?650?S Посібник користувача та інструкція з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача та інструкція з монтажу для Спікери BluCube CXC?650?S. BluCube CXC?650?S 11 сторінок. Circular, flush-mount, in-wall/in-ceiling loudspeakers
Також для BluCube CXC?650?S: Посібник користувача та інструкція з монтажу (13 сторінок)

Друкувати сторінку

The first step in installing flush-mount loudspeakers in a pre-existing

construction is to establish the location of the ceiling joists or wall studs.

You may be able to do this by lifting upstairs floorboards or stud finding

tools. If not, you may need to make pilot holes and a probe but recognise

this may entail making good afterwards.

Once a suitable location is identified, you will need to cut out the correct

size opening in the surface of the plasterboard using the supplied cut-out

template and a padsaw. You should make a pilot hole first and take care not

to cut into pre-existing electrical cables or pipe-work.

You will need to run speaker cable from the opening back to the amplifier

(in the case of the Single-stereo model CXC-650-S you will need two

cables). Ensure you comply with any building codes that may apply in your

location.

Fitting the speaker into the cut-out opening

Before inserting the speaker into the opening in the wall/ceiling, attach the

speaker cable(s) to the speaker, taking utmost care to ensure the correct

polarity of the speaker wires as this is critical to the correct operation of the

speakers.

Insert the speaker housing into the opening and tighten the mounting

screws to engage the "swing-dog" fasteners. Be careful to not over-tighten.

The "swing-dog" fasteners will clamp the speaker frame and the mounting

surface together.

To insert the speaker grille, start on one edge and slowly work your fingers

around the grille edges to ease into the groove. Make sure all edges are in

the groove before applying pressure to insert. It is a snug fit. Do not push on

the centre of the grille. If the grille is not going in, it means that not all edges

are in the groove. Ease the grille off and start again.

If the grille needs to be removed, use the supplied finger hook tools to

gently ease it out of the housing.