BluCube CXC?800?3 Посібник користувача та інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача та інструкція з монтажу для Спікери BluCube CXC?800?3. BluCube CXC?800?3 11 сторінок. Circular, flush-mount, in-wall/in-ceiling loudspeakers
Також для BluCube CXC?800?3: Посібник користувача та інструкція з монтажу (13 сторінок)

Друкувати сторінку

Features

Your BluCube

loudspeakers feature the following:

•

Woven Kevlar

and consequently is found in many of the world's finest loudspeakers. Its combination of stiffness

and strength-to-weight ratio means that it results in a more precise and defined sound reproduction.

•

Titanium tweeters: Another feature often found in the world's finest loudspeakers. The stiffness

and lightness of a titanium dome tweeter results in cleaner, brighter audio definition.

•

Adjustable tweeters: The tweeters in your BluCube loudspeakers are mounted in an orbital socket

and can be adjusted by gently pressing on their edge. This adjustment allows for directing the

sound when the speaker may need to be offset from an ideal listening position due to aesthetic or

physical reasons.

•

Stable tweeter housing: The tweeters in our circular flush-mount loudspeakers are mounted on a

supremely stable bridge rather than on a central pole as found in many current designs. This allows

the speaker to handle more power with increased cone stability resulting in lower harmonic

distortion.

•

4/8 ohm impedance switching on the circuit board: The ability to switch between 4 ohms and 8

ohms impedance is useful to match the speakers to your amplifier and is also useful if you wish to

set up multiple pairs of speakers connected to a single amplifier.

•

Attenuation Switches: Your BluCube loudspeakers are fitted with high frequency (tweeter) and

low frequency (woofer) attenuation switches (and midrange on CXC-800-3). These enable you to

adjust the sound properties of the speaker to suit your personal listening preferences and the

acoustic properties of the room in which you are installing them.

•

Cut-out template: BluCube loudspeakers come with a cut out template to allow the installer to

accurately measure the hole to be cut out in the wall or ceiling surface resulting in an easier

installation process.

•

Paint Mask: BluCube loudspeakers come with a paint mask to allow the installer to protect the

surface of the tweeter and the woofer cone while (optionally) painting the surrounding speaker

baffle.

•

Pre-construction bracket: All BluCube loudspeakers come with tough, plastic pre-construction

brackets. Their use is optional, but can be very helpful to the installation process at the time the

plasterboard is about to be attached to the wall/ceiling. Therefore they would be used only during

more extensive renovations and not when fitting the loudspeakers into an existing surface.

•

Paintable Grilles: Your BluCube loudspeakers come with steel grilles pre-painted in white. These

may be painted if required. Important: Please refer to the section later in this manual on painting

grilles before embarking on this.

•

Grille removal tool: Your BluCube loudspeakers come with a pair of finger hooks to facilitate the

removal of the grilles in the event that you wish to adjust or remove your loudspeakers.

•

Installation Guide: This installation guide is included with your BluCube loudspeakers. From time

to time we will publish updates to the guide and so you may wish to refer to our web site for the

most up to date version.

Cones: Kevlar

has physical properties that make it ideal for loudspeaker drivers