DNF Controls 4000CL-O Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Контролер DNF Controls 4000CL-O. DNF Controls 4000CL-O 19 сторінок. 400 video clip fast access system with odetics protocol

Друкувати сторінку

13. TRANSFER CUE LIST

a.

TRANSMIT CUE LIST FUNCTION

The TRANSMIT CUE LIST function allows you to transmit your list of Cue Points to a
PC, using the provided utility software on the PC, or to another ST300. Transfer to a PC
requires OpSuite 3.0 software, which runs on a Windows-based computer. Contact DNF
Controls for more information.
1)
2)
11
4000CL-O, 400 Clip Fast Access System, Odetics Protocol
To Transmit Cue Points to Another ST300:
a)
Connect the VTR4 connector on the rear of the ST300 to the VTR4
connector of the receiving ST300 using an RS422 9-pin cable with TX
and RX lines crossed. (A "turnaround" cable.)
b)
Press [MENU].
c)
Scroll the Wheel until "Transmit CUE list? YES=Enter, Exit=ESC" is
displayed.
d)
Press [ENTER] to start transmitting. The Display shows "Waiting to
transmit" on the first line.
e)
When the Receiver is ready, transfer starts automatically. The Display
now shows "Transmitting cuelist."
f)
After the transfer is over, the display shows "Transfer is over" for one
second and then shows "Waiting to transmit" again.
g)
Connect another ST300 to transmit the list again.
OR
Press [ESC] twice to exit the MENU mode.
To Transmit Cue Points to a PC:
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using a RS422 to RS232 adapter.
b)
Repeat steps a) thru g) of "To Transmit Cue Points to Another
ST300," Section 11.a.1).