DNF Controls 4000CL-MAV-T-PBIO Посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник користувача для Мережева карта DNF Controls 4000CL-MAV-T-PBIO. DNF Controls 4000CL-MAV-T-PBIO 20 сторінок. 250 clip fast access system with peripheral bus interface option for sony mav-555 video servers
Також для DNF Controls 4000CL-MAV-T-PBIO: Посібник користувача (20 сторінок)

Друкувати сторінку

ST300 SETUP

DISPLAY

SOFTWARE

VERSION

SYNC

VIDEO STANDARD

RECALL MODE

PARITY

RECORD

PBIO ADDRESS

SWITCHER TYPE

TRANSMIT CUELIST

RECEIVE CUELIST

15 4000CL-MAV, 250 Clip Fast Access System, for Sony MAV-555, with PBIO option

ST300 SETUP

Clear Cues

Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.

Press Softkey [YES] when asked "Are You Sure?"

Press Softkey beneath SetDefault to set ST300 to default settings.

Press Softkey [YES] when asked "Are You Sure?"

The version number for the currently installed software is displayed.

Set to ON if black burst is supplied to the Ref Video connector on the rear

panel. Set to OFF if no black burst is supplied.

Sets Video Standard option to NTSC when [NTSC] is pressed.

Sets Video Standard option to PAL when [PAL] is pressed.

Press [NORMAL] or [REDIR] (redirect).

NORMAL –

The cue point will load on the learned VTR.

REDIR –

When one and only one clip is learned into a Cue Point, the Clip will be

REDIRECTD to load on the currently selected VTR.

In hardware version 3.0 only, set the parity to the same as the switcher.

For hardware versions 2.0 and 2.1, no adjustment is provided or required.

Press Softkey to select single button or 2-button record.

RECORD = [REC] Only OR [REC] + [PLAY].

Select to match the switcher output. (ALL hardware versions)

Select to match the switcher type. (ALL Hardware versions)

Transmit cuelist to another ST300 or to a PC.

Receive cuelist from another ST300 or PC.

SetDefault