DOA HD 13 Посібник з техніки безпеки, експлуатації та обслуговування - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з техніки безпеки, експлуатації та обслуговування для Дриль. DOA HD 13. DOA HD 13 18 сторінок. Hydraulic hammer drill
Друкувати сторінку
4. DISCONNECT THE TOOL FROM THE OIL FLEXIBLE HOSE RELEASING FIRST THE PRESSURE
HOSE ( IS THE UPPER HOSE NEAR THE HANDLE) CORRESPONDING TO THE HOLE WITH P – IN
THIS OPERATION WILL PREVENT ACCIDENTAL PRESSURE TRAPPING INSIDE THE TOOL.
5. DISCONNECT THE FLEXIBLE OIL HOSE FROM THE POWER PACK
6. ROLL UP THE OIL FLEXIBLE HOSE IN CIRCLES OF ABOUT 60 CM OF DIAMETER, CONNECTING
THE QUICK COUPLERS AT THE EXTREMITIES IN THE "HEAD/TAIL" WAY. THIS OPERATION WILL
PROTECT THE OIL COUPLERS AGAINST IMPACTS OR SCRAPING AND WILL ALSO HELP IN
KEEPING THE HOSE WELL ROLLED UP.
7. DETACH THE BIT FROM THE TOOL IF NEEDED, CONTROL THE STATE AND EFFICIENCY OF
THE BIT AND DISCARD THOSE DAMAGED TO AVOID THAT CAN BE REUSE
8. STORE THE EQUIPMENT IN A SAFE PLACE REPAIRED FROM BUMPS AND ATMOSPHERIC
AGENTS
9.
IF THE EQUIPMENT SHOULD BE TRANSPORTED ON VEHICLES OR TRUCKS, TAKE CARE THAT
IT IS LOADED AND BLOCKED IN A PROPER WAY FOR AVOIDING TILTING AND DAMAGES.
AFTER USE IN UNDERWATER WORKS
AFTER THE USE IN UNDERWATER WORKS AND ABOVE ALL IN SALTY WATER
•
- AFTER USE THE TOOL MUST BE IMMEDIATELY ACCURATELY WASHED WITH FRESH
WATER, INSISTING IN THE RECESSED CAVITIES AND HIDDEN POINTS WHERE SALT MAY
NEST
•
- THEN WITH AN AIR GUN ACCURATELY REMOUVE ALL TRACES OF WATER ( THE FRESH
WATER )
•
- THEN SPRAY TOOL WITH WD40 OR CRC OR OTHER DEWATERING MOISTURE RUST
NEUTRALISING PRODUCT
•
- SPRAYING WELL WD40 OR CRC INSISTING IN THE RECESSED CAVITIES AND HIDDEN
POINTS
•
- THEN BETTER WRAP TOOL IN A PLASTIC WRAP TO AVOID ANY CONTACT WITH METAL
AND SALTY AIR
•
- IF POSSIBLE PLACE TOOL ON WOOD AND PLASTIC SURFACE ( NEVER ON METAL
SURFACE) IN A DRY PLACE THIS WILL PREVENT GALVANIC OXIDATION
MAINTENANCE AND CARE OF THE PRODUCT
THE TOOL CLEANING IS ESSENTIAL FOR THE GOOD FUNCTIONING OF THE EQUIPMENT. A CLEAN
PRODUCT WILL IMMEDIATELY ALLOW TO FIND OIL LEAKS OR CAUSES OF MALFUNCTIONING. A
CLEAN TOOL IS ALSO MORE COMFORTABLE FOR THE OPERATOR AND GUARANTEES A FIRM
GRIP.
CLEANING WITH CLOTHS OR PAPERTHE TOOL CAN BE CLEANED WITH A DAMP RAG, USING A
BRUSH WITH GASOHOL OR AN AIR GUN FOR ELIMINATING ALL TRACES OF DIRT AND OIL
CLEAN IN PARTICULAR THE RECESSED POINTS AND CAVITIES AND THE CONNECTION SURFACE
OF THE QUICK COUPLERS.
CLEANING OF THE TOOL