dobar Stellar Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Камін на відкритому повітрі dobar Stellar. dobar Stellar 11 сторінок. Gas fire pit

Друкувати сторінку

INSTALLATION

Packed components list
Item
A
B
C
D
E
Set up
This Gas Fire Pit must be installed on flat, stable surface, away from any combustible materials or
Remove fire pit from a carton and remove cylinder cargo from another carton, place them on any level,
non-combustible surface.
Place lava rocks into the fire pit around the burner evenly.
Unscrew the button cap of igniter, put a piece of AAA battery into igniter compartment with anode outward,
then screw the button cap.
Take down the lid of cylinder cargo carefully and put it in the safety place.
Locate the hose out of the pathways where people may trip over it or in areas where the hose may be
subjected to accidental damage.
CAUTION: Do not kink flexible gas hose. If it is kinked, a gas leak could occur.
Instruction for connecting gas circuit to LPG cylinder
Keep at hand suitable crossed screwdriver, adjustable spanners, pliers and wrenches. Before assembly, make
sure all protection packing material has been removed. Flexible gas rubber pipe and clamps (if necessary) are
supplied with this appliance and must be used, according to National Rules in force. You need to purchase one
gas regulator and one gas cylinder. The gas regulator has to be set according to specific gas category (see on
page 2) and proper gas consumption (g/h) specification. The LPG cylinder should be standard one. Recommend
to use 4.5kg to 15 kg one. Replacement must be that specified in "Gas Requirements" section of this Instruction
Manual. Be careful: do not kink flexible gas rubber pipe of gas circuit. If pipe holder should not be provided, thread
of the gas inlet connection will be in line with Standards ISO 7-1 or ISO 228-1, according to National Rules in force
of the country of destination.
Make sure appliance gas knob is turned "OFF" (full disk) before assembling (see below Figure).
Position the LPG cylinder at the side of your appliance, not underneath, keeping in mind that the LPG cylinder
must be kept away from heat and in a safe position.
Connect the regulator to LPG cylinder by hand
Connect the hose to the appliance and the regulator. Tighten the screw of the hose clamp with a screwdriver.
Description
Fire Pit
Fabric dust cover
Lava Rock
Adjusting pin
Metal cylinder holder
Quantity
1pc
1pc
2kg
4pcs
1pc
construction.
6 of 11