Dobinsons MRR Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Пульт дистанційного керування Dobinsons MRR. Dobinsons MRR 8 сторінок. Adjustable remote reservoir shock absorbers

Друкувати сторінку

Important: When adjusting the dials do not over toque the dials. Each dial should

be able to be moved by hand or with the small adjustment tool provided. Do not

over-torque the dials at the end of the dial travel as this may cause permanent

damage to the components.

Compression

The compression adjusters operate by allowing a low speed bleed path combined with a high

speed digressive shim stack to allow adjustments in both the low speed shaft movements and

high speed shaft movements (note - this is not vehicle speed). It is important to note that due to

the nature of the low speed bleed path bypassing the high speed compression stack that each

adjuster does have a small effect on the other i.e. the low speed will have a small effect on the

high speed and vice versa. Also, the higher the adjuster is set to, the more affect the opposing

adjuster will have with each click.

Low Speed Compression

Low Speed Compression ( ( ( ( LSC

Low Speed Compression

The low speed adjustment is increased by turning the smaller adjustment dial on the reservoir

clockwise and is decreased by turning it anti-clockwise and has approximately 20 clicks. Low

speed compression primarily affects the compression damping during low speed shaft

movements such as vehicle pitch, dive and roll, wheel traction and vehicle ride (harshness and

plushness). Lower settings will provide a smoother more compliant ride but will sacrifice

stability whilst higher settings will result in a firmer less compliant ride but provide better body

control & stability. If unsure, choose a setting that you feel provides good vehicle body control

and stability without excessiveness harshness. If you are unable to achieve a firm enough

setting you can increase the high speed adjustment to suit and if you are unable to achieve a

soft enough setting then you may reduce the high speed adjustment. See the graphs below for a

sweep of the low speed compression adjustments – NOTE: Every 2nd click has been omitted for

clarity. High speed compression set at midpoint.

Adjustment

LSC) ) ) )

LSC

Page 2 of 8