ET&F 610 Інструкція з експлуатації та правила техніки безпеки - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та правила техніки безпеки для Цвяходер. ET&F 610. ET&F 610 20 сторінок.

Друкувати сторінку

ACCESSORIES

WARNING
Accessories other than those shown below can
lead to malfunction and resulting injuries.

STANDARD ACCESSORIES

1
1 Eye protector
2 Allen wrench for M6 screw
3 Allen wrench for M5 screw
4 Allen wrench for M4 screw
5 Oil feeder
6 Nose cap

APPLICATIONS

Gypsun wall board to steel studs 12 gauge and lighter

BEFORE OPERATION

Read section titled "SAFETY" (pages 3 – 5).
Make sure of the followings before operation.

WORKING ENVIRONMENT

WARNING
No flammable gas, liquid or other flammable
objects at worksite.
Clear the area of children or unauthorized personnel.

AIR SUPPLY

DANGER
Never use oxygen, combustible gases or any other
bottled gases.
6
5
3
2
4
1
1
1
1
1
1
Never connect Nailer to pressure which potentially
exceeds 200 psi (13.7 bar 14 kgf/cm
Never use non relieving coupler on Nailer.
1. Power source
Use only clean, dry, regulated compressed air as a
power source for this Nailer.
Air compressors used to supply compressed air to this
Nailer must comply with the requirements of the latest
version of ANSI Standard B 19.3 "Safety Standard For
Compressors For Process Industries."
Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter .............. The filter removes moisture and dirt
mixed in compressed air.
Drain daily unless fitted with an
automatic drain.
Keep the filter clean by regular
maintenance.
Regulator ...... The regulator controls the operating
pressure for safe operation of the Nailer.
Inspect the regulator before operation to
be sure it operates properly.
Lubricator ..... The lubricator supplies an oil mist to the
Nailer.
Inspect the lubricator before operation to
be sure the supply of lubricant is adequate.
Use pneumatic tool lubricant.
Nailer Side
3. Air hose
Air hose must have a minimum working pressure
rating of 150 psi (10.4 bar 10.6 kgf/cm
maximum pressure produced in the system, whichever
is higher.
4. Hose coupling
A female coupler must be on the air hose.
The hose coupling (male plug-female coupler) must
remove all pressure from the Nailer when disconnected.
Never use a non relieving coupler on the Nailer.
5. Air consumption
Using the Air consumption table and the Air
compressor size formula, find a correct compressor size.
— 8 —
WARNING
2
).
2
).
Regulator
Compressor Side
Filter
Lubricator
2
) or 150% of the