Fleck 7000 Посібник зі встановлення та запуску - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник зі встановлення та запуску для Диспенсер для води Fleck 7000. Fleck 7000 12 сторінок. Birm filter
Також для Fleck 7000: Посібник з програмування (4 сторінок)
Друкувати сторінкуFleck 7000 Birm Filter Installation & Startup Guide
Assembly and Installation Instructions
1. Unscrew by hand the entire Fleck 7000 control valve from top of tank if it was shipped screwed
on. Place distributor tube in tank if not already inside tank. If not already done, make sure blue
cap is on top of distributor tube, or wrap the top of distributor tube with electrical or duct tape.
You do not want gravel or Birm to go down the distributor tube.
2. Add the filter gravel that came with your order. You want the gravel to cover the bottom
distributor screen before adding the Birm media.
3. Next add Birm media. The tank will be about 2/3rds full of media.
4. Remove cap or tape from top of distributor tube. Be careful not to pull up distributor tube
when removing cap or tape.
5. If possible at this point, fill tank completely with water. This will allow the Birm Filter media to
settle and eliminate the need of "purging" the air out of the tank later.
6. Attach plastic top screen to the under-side of the Fleck 7000 control valve. It is a funnel-shaped
plastic screen that snaps on to the control valve and prevents resin from being backwashed out
to drain during the regeneration cycles.
Page 8
www.cleanwaterstore.com
Rev 101812