1000espressos MAXIMA XL Інструкція

Переглянути онлайн або завантажити pdf Інструкція для Кавоварка 1000espressos MAXIMA XL. 1000espressos MAXIMA XL 2 сторінки. 2/3groups

Instructions

Model: MAXIMA XL – 2/3Groups

Note: Do not install the machine without reading this manual first. Serious damages can be

caused to the machine if the installation is not done properly!

1- Steam and water levers

2- Cups warmer

3- Touchpad with 5/6 blue buttons

4- Electronic level of water

5- Pressure gauges

6- Main switch

7- High groups type E-61

8- Water spigot

9- Steam wand

10- Stand for cups

11- Service tray and drain

12- Adjustable legs

Features:

Power: 2.600 / 3.500 Watt

Capacity Boiler:

2 /3 groups: 12 /18 Liters

1- START – INSTALLING THE MACHINE

This '1000espressos' model is a medium range, 2 group professional espresso machine.

Before we plug the machine, we must connect the inlet water and drain pipes and make

sure that the installation of the local (bar, restaurant, etc) is according to law, with enough

power to install a coffee machine and a proper earth connection. This machine is a single

phase, 220/230V and 50 Hz, but it can also be supplied at 110V/60Hz.

So, please check the points described down here before turning on the machine:

1- Connect the gray drain pipe to permit the machine to drain properly.

2- Make sure also that the metallic inlet water pipe is well connected.

3- Install a plug on the main cord, and connect the machine to power (Usually the

machines come with 4 cables on the main cord. Blue –neutral, Yellow/Green –

earth, Brown – 1 phase, Black – 1 phase. You can wire together the Brown and

Black to get only 1 phase).

After the machine is plugged, connected to drain and to water inlet pipe, then we can

proceed to TURN it ON...

...NOW THE MACHINE IS READY TO WORK!

2- FIRST TIME CONNECTION

1- Please place the main switch to position 2 (indicated on the panel). This will allow

the machine to start filling the boiler keeping the heating element Off.

2- If the boiler is not full after 120 seconds, touch pads will blink. If this happens,

place the main switch to position 0 and start again.

3- When the boiler is filled of water, we must place the main switch to position 1,

which will permit the heating element working.