fleetfinder GOLD Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для GPS fleetfinder GOLD. fleetfinder GOLD 19 сторінок.

Друкувати сторінку

It is strongly recommended that the units SIM card is first registered,

contains credit and is tested before installation is commenced. Testing

will require a valid SIM service. For GPRS online tracking, the SIM card

MUST be GPRS enabled. When installing the GPS antenna, make sure

that the coaxial cable does not get bent or crimped.

Always keep fleetFinder's phone number confidential and account paid

up for pre-paid services.

Remember your fleetfinders PIN & phone number, no one else should

know them. For Online tracking, please ensure that the SIM Card is GPRS

enabled (For more information on this please contact your SIM car service

provider)

Outputs are NOT recommended for use to directly or indirectly immobilize

an operating vehicle. Immobilizing a vehicle in motion is extremely

dangerous. The general purpose outputs are to be used to disable the

vehicle's starter motor only.

This device is not to be used for unautorised monitoring or tracking.

Do not operate this device where mobile phones or radio transmitters are

not permitted. Do not operate on aircraftd. Do not operate near sensitive

electronics such as engine, brake or air-bag systems.

Electrical safety:

Designed to work from 12 volt or 24 volt DC only. Use 5 amp inline fuse.

Explosive Atmosphere:

The fleetminder GOLD uses the GSM network, and it is not advisable to

request tracking during refuelling, at blast sites or at chemical

sites etc.

Medical Equipment:

Some medical devices such as pacemakers may be inhibited by

GSM signals. Check with a doctor or medical equipment

manufacturers for more advice on this issue.

Aircraft safety:

When transporting this equipment by air, ensure the unit is totally

disabled, by removing the SIM card from the SIM card slot. And ensuring

the Red power LED is switched off. (If the Red LED is flashing, press

and hold reset button for 4 seconds, until all lights switch off.)

Other Precautions:

Outputs:

- The outputs are rated at 300mA max.

- As default the outputs are set to trigger a low. (ground)

- Due to outputs being limited to current, we recommend using a Relay

for outputs.

- The ouputs can be configured for a latch (permanent switch) circuit, a

pulse (800mS pulse) circuit (normally used for central locking circuits)

or cycle circuit (normally used for flashing indicators)

NOTE: Cycle will only last for 30 seconds.

- The outputs are most commonly used for Unlocking doors, Sounding

horn and disabling starter motor, but can be used for almost anything.

Inputs:

- The inputs can be connected to almost any electronic circuit, however

please note that there are 2 positive triggers (+12V or +24V) inputs,

and 1 negative trigger (GND) input.

Refer to the Installation manual for more information.