FleetSharp atsolar Посібник із швидкого старту - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для GPS FleetSharp atsolar. FleetSharp atsolar 3 сторінки. Asset tracker
Також для FleetSharp atsolar: Посібник із швидкого старту (2 сторінок)
Друкувати сторінку
Installing Your Solar Asset Tracker
1
Your solar tracker is set to shipping mode to preserve the battery.
Before use, hold down the black button on the side until you see a light.
2
The FleetSharp solar asset tracker can be attached to your equip-
ment with magnets or by using 10-24 x 1 sized screws (not included).
ATSolar devices should be mounted on a flat surface.
Do not over tighten and do not bend the device. Do not use glue or
other drying adhesives; they can block a small vent on the back of
the tracker. Make sure it is installed in a location that has access to
sunlight.
Install Positioning Matters
Asset
Strong signal:
Installed with clear
line to sky
Not intended for use:
• Indoors
• Inside of metal casings
• Underground
• In remote, "no cell coverage" areas
Performance and results will vary if used in the above environments.
If you need help or have any questions, contact us at
Weak signal:
Installed vertically
1-844-498-9450
Solar Tracker Installation
Asset
Limited signal:
Installed under
asset
or