DocuSign Signature Appliance Інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Сервер DocuSign Signature Appliance. DocuSign Signature Appliance 11 сторінок.

Two sets of the following:

 4 M4x12 screws

 4 M4 washers

 4 M4 nuts

2. Attach a rail to the rail-supports on the right side of the rack, as follows:

a. Place a rail with its back to the rail-supports. The rear end of the rail should be flush with

the rear end of the rear rail-support.

b. Pull the rail's telescopic section out to the end of its travel to reveal the slots in the rail

backing. These slots are used to secure the rail to the rail-supports.

c. Secure the rail to the front rail-support using two M4x12 screws. Each screw should first

pass through a slot in the rail backing and then through the center slit of the rail-support.

Secure each screw with an M4 washer and an M4 nut. Place the two screws in the

locations indicated by the red ovals in

221 Main Street, Suite 1000, San Francisco, CA 94105

Figure 4

Figure 5

Figure

Figure 6

Tel. 866.219.4318