Clinton 6361 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Медичне обладнання Clinton 6361. Clinton 6361 8 сторінок. Power series, bariatric, blood drawing chairs
Друкувати сторінкуCLEANING
METAL
Metal frame should be cleaned according to facility antimicrobial standards and dried with a clean soft cloth.
Never use abrasive cleaners or scrubbing implements on painted surfaces.
UPHOLSTERY
Clinton uses only premium vinyl for upholstery, however, care should be taken when cleaning to ensure that the
upholstery or color is not affected by the cleaning agent. Use only mild cleaning agents on upholstery. Clinton
recommends using a 1 to 1 mix of ammonia and water or a 1 to 4 mix of bleach and water. Rinse thoroughly
with clean water and pat surface dry. This is not a guarantee and does not relieve the user from responsibility of
the proper and safe use of all cleaning agents. Test on inconspicuous area prior to using any cleaning agent on
upholstery's visible surface. Certain cleaning agents can be harmful to the surface.
WARNING:
according to standard procedures of your particular healthcare or therapy facility. Although Clinton
recommends a cleaning solution it is not a guarantee that it will meet with your facility's standards
or state, federal and local standards for treatment and cleaning of areas and equipment that may be
exposed to pathogens and infectious materials.
TROUBLE SHOOTING
PROBLEM: Chair stopped, won't respond to controller.
SOLUTION: Reset the lift power sources.
Resetting the Power Source
Foot Controlled Dual Column Chairs
Reset Button
6
Always clean surfaces that come in contact with pathogens or infectious materials
Controller
a.) Locate Reset button, usually in the left front of
the chair underneath the seat, See reset button
photo.
b.) Push and hold the reset button, you will hear a
fast pace beeping.
c.) When the pace of the beeping slows down,
release the reset button.
d.) Alternate pressing the PLUS and MINUS
buttons, on the foot control, for about
1 second each. This will drive each column
down individually, so as to not bind the chair/
columns. When the columns are all the way
down the beeping will stop. See controller
photo.
e.) Your chair should be reset and operate correctly