Etac Molift Smart 150 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Підйомні системи Etac Molift Smart 150. Etac Molift Smart 150 20 сторінок.
Також для Etac Molift Smart 150: Посібник користувача (19 сторінок)
Друкувати сторінку
Assembly / disassembly
Unpacking
• The lifter comes in one cardboard box. Verify
that the box has no apparent damage. If dam-
aged, check the content and contact your deal-
er for assistance if components are damaged.
• The box contains one complete Molift Smart
lifter with hand control, battery and battery
charger.
Assembly
The battery must not be in the battery holder
during assembly!
• Remove the transport elastic and spread the
legs to working position (maximum width).
Transport position
Working position
The legs must be spread to working position
before the column can be mounted.
• Lift up the lifting column and slide it into the
bracket on the chassis.
BM09201 Molift SMART 150 English - Rev E 10/2012
• When the column has placed itself in the bot-
tom of the bracket, it must be fixed with the
locking handle on the back of the chassis. Push
the locking handle down (1) and make sure the
column is properly fixed.
• Lift the suspension out of the transport hook.
Max width
Do not start to run the lifting arm before the
suspension is released!
• Insert the battery into the battery holder and
verify that the emergency stop button isn't ac-
tivated. Run the lifting arm up and down with-
out load to verify that it is working properly.
Check that the lifter is mounted correctly with
no loose part or damages. Ensure that the
lifting column is fixed properly, and that the
legs do not move inside working position.
Checklist after mounting.
• Check the lifter according to the checklist be-
fore use on page 7.
The column must be
placed in the bottom of
the bracket on chassis as
shown on the illustration
to the left.
Page 5 of 20