ClipperCreek CS EVSE Pedestal Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу для Стелажі та підставки ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 сторінок. Electric vehicle supply equipment

Друкувати сторінку

INITIAL PEDESTAL INSTALLATION (continued)

6..Install.the.Conduit.Assembly

The service conductors are routed through the side

of the pedestal and into the back of the EVSE via an

external conduit assembly. NOTE:.For.a.Dual-Mount.

installation, these instructions must be repeated for

the.opposite.side.

For.the.Standard.¾".Conduit.Assembly:.

Follow these instructions and refer to Figure 9 to

install the standard ¾" conduit assembly included in the

pedestal kit.

•

It is highly recommended that connection

to the Ground Lug inside the Pedestal Post

be completed at this time. Access will be

limited.after.this.step.

•

Remove the ¾" plastic plug located 12" down

from the top of the pedestal on the left side.

•

Unscrew locknut (a) from the end of the

conduit.

•

Route the three conductors through the

following:

a) The inner locknut (inside of the pedestal)

b) The open pedestal hole

c) The first plastic washer (make sure the

washer is on the outside of the pedestal)

d) The conduit assembly

e) The second plastic washer (make sure the

washer is on the outside of the EVSE)

f) The outer locknut

•

Push the threaded end of the straight conduit

fitting into the open pedestal hole. Reach

inside of the pedestal and hand-tighten the

locknut (a) onto the conduit threads.

•

IMPORTANT: Remove the locknut (f) at the

end of the conduit assembly; this will be

needed in a later step. See locknut (f) in

Figure 9. Face the open end of the 90 degree

conduit fitting forward for later insertion into

the back of the EVSE.

CS EVSE PEDESTAL INSTALLATION GUIDE

Figure.9:.Standard.3/4".Conduit.Assembly

e. f.

Page 11

ClipperCreek

, Inc.