Dog trace d-control 1040 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Засіб для догляду за домашніми тваринами Dog trace d-control 1040. Dog trace d-control 1040 15 сторінок. Electronic vibration training collar
Також для Dog trace d-control 1040: Посібник (18 сторінок)
Друкувати сторінку
When the battery is low or flat, insert a new CR2 3V lithium battery into the receiver.
7.3 Switching the receiver ON/OFF
A magnet located at the lower part of the transmitter is
used to activate or deactivate the magnetic switch
located in the receiver.
Switching ON:
Approach the low area of the transmitter where the
magnet is located until coming close to the indicator
located on the receiver (see the picture), hold for
1 second, the receiver LED indicator will flash in green
indicating the receiver is ON.
Switching OFF:
Approach the low area of the transmitter where the
magnet is located until coming close to the indicator
located on the receiver, hold for 1 second, the receiver
LED indicator will flash from green to red indicating the receiver is OFF.
IMPORTANT: When switching on or off, simply hold the transmitter against the
receiver target for approximately 1 second. If you hold for more than 5 seconds,
the receiver will go into transmitter-receiver pairing mode. This mode is
indicated by the green and red indicator lights flashing simultaneously. If this
occurs, follow the steps in the section 8 Programming (coding) the transmitter
with the receiver.
To extend the battery life it is necessary to switch off both receiver and transmitter
after the training is finished. If the battery will not be in use for a month or longer,
it is recommended that it is removed from the receiver.
8
PROGRAMMING (CODING) THE TRANSMITTER
Each transmitter has its own RF operational code. The pairing needs to be done to
make the receiver and transmitter operate together. When you receive a new set
the pairing is done by manufacturer. The pairing is done, when you need to use
different transmitter or receiver (for example when bought a new one).
The transmitter is made for training of two dogs, so you can pair it with two
receivers. Use the button
IMPORTANT: Before the programming make sure no other person is using his
d-control or other products from the Dogtrace range close by: your receiver
could accidentally record the code of his transmitter.
22
WITH THE RECEIVER
/
to choose the right dog.
Switching ON/OFF the
transmitter/Programming
the transmitter with the
receiver