Dog trace d-control 1500 mini Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Засіб для догляду за домашніми тваринами Dog trace d-control 1500 mini. Dog trace d-control 1500 mini 20 сторінок. Electronic training collar
Також для Dog trace d-control 1500 mini: Посібник користувача (19 сторінок)

Друкувати сторінку

Programming (pairing) the transmitter with the receiver

Each transmitter has its own operational code. The programming of the transmitter with the receiver

enables the two units to work together. This operation will help you to program the receiver to work

with a new transmitter or to program a new receiver to work with your existing transmitter. Receiver

can be reprogrammed indefinitely, either with the same transmitter or a new d-control transmitter. It

is possible to program an unlimited number of receivers to one transmitter.



IMPORTANT: Before the programming make sure no other person is using his d-control or

other products from the Dogtrace range close by: your receiver could accidentally record the

code of his transmitter

Switch on the transmitter. The receiver must be switched off.



Select dog 1 using the button



Approach the low area of the transmitter where the magnet is located until coming close to the



indicator located on the receiver (see the picture on the page 8), hold for 5 second, the receiver LED

indicator will flash four times in green and red simultaneously indicating the receiver is in

programming mode.

Move your transmitter away and press the tone signal button



is emitted; the receiver is then synchronized with the transmitter.

Select dog 2 using the button



programming an additional receiver for the second dog).

on the transmitter.

on the transmitter and proceed in the same way (applicable when

on the transmitter. A beep sound