Dog trace d-control 1640 Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Засіб для догляду за домашніми тваринами Dog trace d-control 1640. Dog trace d-control 1640 15 сторінок. Electronic vibration training collar
Також для Dog trace d-control 1640: Посібник (18 сторінок)
Друкувати сторінку
8.1 Pairing of the button
1. Turn ON your transmitter.
2. The receiver has to be turned OFF.
3. Press the button
4. Move the lower part of the transmitter to the target on your receiver (see the pic.
on page 22) and hold in position so the green LED is steadily lit. After
approximately 5 seconds it will switch to the pairing / programming mode,
indicated by flashing of the red and green LED at the same time (4x).
5. Then take your transmitter away from the receiver and press down the audible
beep tone button
has been successful.
8.2 Pairing of the button
Press the button
first receiver above (this can be followed when you use d-control 640, 1040, 1640
with a new purchased receiver).
8.3 Reprogramming of your receiver
The receiver can be programmed repeatedly without restraint using the same
transmitter or another (see the section 8 Programming (coding) the transmitter
with the receiver).
TIP: It is possible to program an unlimited number of receivers to a one
transmitter.
Example: Button
one or we can set all 3 in pairing regime and then press button for audible beep
tone. All these receivers will perform the same action at the same time when
pressing function button. This can be used for two collars on the neck of one dog,
or for the training of higher number of dogs, where we give the same commands to
all of them at the same time.
8.4 Fitting the collar
The strap with the receiver (receiver collar) must be tightened enough so that the
contact points are in contact with the skin of the dog. We recommend you to fit the
collar on the standing dog. When you can fit two fingers between the collar and your
dog's neck, the collar with the receiver are tightened enough. If a dog has long or
thick hair, it is suitable to trim the hair in the area of the contact points or to switch to
the longer contact points to ensure a consistent contact.
with the first receiver
for the first receiver choice.
on your transmitter. If you hear the beep tone the pairing
with the second receiver
for the second receiver choice and follow the steps as for the
is paired with 3 receivers, they can be programmed one by
23