Dog trace d-control 300 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Засіб для догляду за домашніми тваринами Dog trace d-control 300. Dog trace d-control 300 15 сторінок. Aqua spray
Друкувати сторінку
Receiver preparation
Inserting (changing) the receiver battery
1. Remove the 4 screws from the underside of the
receiver and remove the lid from the top.
2. Insert the lithium CR2 3 V battery with the co-
rrect polarity (polarity is marked in the battery
compartment).
When inserting battery for the first time, or if the
battery is removed for longer than a couple tens
of minutes (approx. 20 minutes), a beep sounds
to indicate that battery has been inserted
correctly.
Note: When the battery is replaced quickly, the
beep may not sound.
3. Check that the rubber seal is correctly positio-
ned in the receiver lid groove. If the rubber seals
are dirty, clean them.
4. Put the lid back on the receiver and replace the
screws.
Checking the receiver battery's status
To check the receiver battery, see the indicator light (LED) on the upper side of the
receiver (see chapter): Product description - Receiver.
Charged battery – when on, the LED flashes green
Low battery – when on, the LED flashes red
If the battery is flat, insert new lithium battery CR2 3 V into the battery compartment.
Switching the receiver on/off
To turn the receiver on/off (e.g., when pairing
the transmitter and receiver), use the magnetic
switching
system,
the magnet stored in the lower part of the
transmitter near the correct receiver part.
Switching on:
1. Place the lower part of the transmitter near
the red target on the receiver (see picture) -
indicator light will shine red, then orange.
2. Once the light is orange remove the
transmitter from the receiver - the light will
shine green and start to flash.
activated
by
placing
9